DD15 SPN 164/FMI 4 Troubleshooting

SPN 164/FMI 4

SPN 164/FMI 4 indicates a Rail Pressure Governor Sensor Circuit Failed Low (short to ground).‪

Check as follows:‪

1. Check for multiple codes.
   1. If faults for the Intake Manifold Pressure/Temperature Sensor are active at the same time, repair the circuits between pin 58 or pin 102 of the MCM 120-pin Connector and pin 2 or pin 4 of the Intake Manifold Pressure/Temperature Sensor. Refer to “31.5.1 Verify Repairs” .
   2. If only fault 164/4 is active, go to the next step.
2. Disconnect the Rail Pressure Governor Sensor.
3. Disconnect the MCM 120-pin connector.
4. Measure the resistance of pin 1 of the Rail Pressure Governor Sensor connector and ground.
   1. If resistance is less than 5 Ω, repair short between pin 102 of the 120-pin MCM connector and ground. Refer to “31.5.1 Verify Repairs” .
   2. If resistance is greater than 5 Ω, go to the next step.
5. Measure the resistance between pin 2 of the Rail Pressure Governor Sensor harness connector and ground.
   1. If resistance is less than 5 Ω, repair the short circuit between pin 2 of the Rail Pressure Governor Sensor harness connector and ground. Refer to “31.5.1 Verify Repairs” .
   2. If resistance is greater than 5 Ω, go to the next step.
6. Measure the resistance between pin 3 of the Rail Pressure Governor Sensor harness connector and ground.
   1. If resistance is less than 5 Ω, repair the short circuit between pin 3 of the Rail Pressure Governor Sensor harness connector and ground. Refer to “31.5.1 Verify Repairs” .
   2. If resistance is greater than 5 Ω, review steps 4 through 6 . If the results are the same, contact Detroit Diesel Customer Support Center (313-592-5800).