The flywheel housing is a one-piece casting mounted against the rear of the cylinder block. It provides a cover for the flywheel and serves as a support for the cranking motor and the transmission.

1. Crankshaft Rear Oil Seal |
3. Outer Bolt (4 long) |
2. Inner Bolt (8 short) |
4. Flywheel Housing |
Related Posts
-
-
Series 60 Rocker Arm PartsThe fuel injector rocker arm assembly is located between the intake and exhaust rocker arm assemblies and has a single…
Series 60 Alternator PartsThe battery charging alternator provides a source of electrical current for maintaining the storage battery in a charged condition and…
Series 60 Lifting Engine A total of three engine lifter brackets are installed on each Series 60 engine and are utilized when removing and…