37.1 SPN 191/FMI 9
This fault is typically the J1939 ETC1 message is missing.
37.1.1
Missing ETC1 Message Check
Check as follows:
1. Check for multiple codes:
[a] If CPC SPN 168/FMI 0/14/18 (Battery Voltage) are present troubleshoot these first.
[b] If MCM SPN 625/FMI 9 is present, troubleshoot and repair the CAN line.
[c] If only a “J1939 Error” fault is present, go to step 2.
2. Has the CPC been recently reprogrammed?
[a] If yes, check the proper configuration of the CPC.
[b] If no, connect ServiceLink to determine which modules are configured for the vehicle
and their communication status. Once this is done, follow the appropriate module
communication troubleshooting procedures for the affected module.
37.2 SPN 191/FMI 13
This fault is typically the transmission output speed shaft signal is missing.
37.2.1
Missing Transmission Output Speed Shaft Signal Check
Check as follows:
1. Check for multiple codes:
[a] If CPC SPN 168/FMI 0/14/18 (Battery Voltage) are present troubleshoot these first.
[b] If MCM SPN 625/FMI 9 is present, troubleshoot and repair the CAN line.
[c] If only a “J1939 Error” fault is present, go to step 2.
2. Has the CPC been recently reprogrammed?
[a] If yes, check the proper configuration of the CPC.
[b] If no, connect ServiceLink to determine which modules are configured for the vehicle
and their communication status. Once this is done, follow the appropriate module
communication troubleshooting procedures for the affected module.
37.3 SPN 191/FMI 19
This fault is typically the transmission output speed shaft signal is erratic.
37.3.1
Erratic Transmission Output Speed Shaft Signal Check
Check as follows:
1. Check for multiple codes:
[a] If CPC SPN 168/FMI 0/14/18 (Battery Voltage) are present troubleshoot these first.
[b] If MCM SPN 625/FMI 9 is present, troubleshoot and repair the CAN line.
[c] If only a “J1939 Error” fault is present, go to step 2.
2. Has the CPC been recently reprogrammed?
[a] If yes, check the proper configuration of the CPC.
[b] If no, connect ServiceLink to determine which modules are configured for the vehicle
and their communication status. Once this is done, follow the appropriate module
communication troubleshooting procedures for the affected module.
