Series 60 – SPN 2659/FMI 0 – EGR FLOW NOT NORMAL

92.1 SPN 2659/FMI 0
The code is typically an EGR flow target error (high flow).
EGR High Flow Check
Check as follows:
1. Inspect the Delta P pressure tubes for damage or plugging.
[a] If damage or plugging is found, repair as necessary. Refer to section
[b] If no damage is found, go to step 2.
2. Inspect the EGR valve for physical damage (broken butterfly).
[a] If the EGR valve is damaged, replace the EGR valve. Refer to section
[b] If no damage is found, replace the EGR Delta P Sensor. Refer to section
Verify Repairs
Verify repairs as follows:
1. Turn ignition OFF.
2. Reconnect any electrical connections that were disconnected to perform the diagnosis.
3. Clear codes with DDDL 7.0 or latest version.
4. Start and bring engine up to operating temperature (over 140°F/60°C).
5. Verify operation is satisfactory and no warning lamps illuminate. If warning lamps illuminate, troubleshoot the codes. If assistance is required, call the Detroit Diesel Customer Support Center at 313–592–5800.

Leave a Reply

Your email address will not be published. Required fields are marked *