Intake valve clearance and injector height are adjusted by means of an adjusting set screw and locknut located at the valve (or injector) end of…
Category: Series 60
Perform the following steps to recalibrate improper injector setting: Note: Injector calibration and bar codes may be absent from the load plates on first-run…
To determine if an improper injector calibration setting is causing the cylinder to misfire, perform the following steps: Remove the valve rocker cover(s); Record…
To determine if aerated fuel is causing the cylinder to misfire, perform the following steps: Disconnect the fuel line return hose from the fitting…
To determine if poor vehicle ground is causing the cylinder to misfire, perform the following steps: Remove alternator belt. Start the engine. Run the…
The ignition coil assembly consists of the ignition coil and integral seal. This is serviced as an assembly, or the seal can be serviced separately.…
Series 60G genset engines use the coil over plug ignition system. This system consists of six coils, six ignition boots, mounting screws and seals, an…
Detroit Diesel Corporation (DDC) has a front mounted PTO, for use on the Series 60 vehicle engines. 1. Retainer 4. Pulley Assembly 2.…
An improved vehicle engine sensor harness which virtually eliminates the potential for wire chafing damage has replaced the former harness on all Detroit Diesel Series…
The DDEC III/IV engine sensor harness for vehicle engines was originally equipped with five metal retaining clips and was secured to the engine cylinder block…