For the Series 60G Genset engines, hoses connect steel piping from the turbo to the CAC, and from the CAC to the throttle. 1. Coupling…
Category: Series 60
1. Raw Water Pump 4. Charge Air Cooler Inlet 2. Charge Air Cooler Outlet Pipe 5. Air Intake Manifold 3. Charge…
Ductwork is used to transfer the air from the turbocharger outlet to the CAC, and from there to the intake manifold. 1. Coupling Hose Clamp…
Cooling is accomplished by incoming air flowing past the tubes and fins of the charge air cooler. The compressed intake charge flowing inside the CAC…
On vehicle and industrial engines, a CAC (charge air cooler) is normally mounted ahead of the cooling system radiator. On keel-cooled marine engines the charge…
The Series 60G automotive GT42 turbocharger requires a boost recirculation valve to reduce air system pressure pulsations and turbocharger surging during engine throttling operations. The…
The turbocharger is designed to increase the overall power and efficiency of the engine. Power to drive the turbocharger is extracted from the energy in…
From the oil inlet in the center housing, the oil flows through the drilled oil passages in the housing to the shaft bearings, thrust ring,…
Oil for lubricating the turbocharger is supplied under pressure through an external oil line extending from the oil filter adaptor to the top of the…
The turbocharger is mounted on the exhaust outlet flange of the engine exhaust manifold. After the engine is started, the exhaust gases flow from the…