1. Exhaust Rocker Arm Assembly 4. Rocker Arm Shaft 2. Fuel Injector Rocker Arm Assembly 5. Cylinder Head 3. Camshaft Cap…
1. Exhaust Rocker Arm Assembly 4. Rocker Arm Shaft 2. Fuel Injector Rocker Arm Assembly 5. Cylinder Head 3. Camshaft Cap…
The fuel injector rocker arm assembly is located between the intake and exhaust rocker arm assemblies and has a single bushing (not serviced separately). A…
Each of the three rocker arm assemblies contain bushings where the rocker arms are supported on the rocker arm shafts. These bushings are not serviced…
The oil pan used on the Series 60 engine is made of plastic (epoxy vinyl ester) or aluminum. For engines built after April 1999, a…
A steel ribbon-type oil level dipstick may be used to check the level of oil in the engine oil pan. The dipstick is located in…
A dual spin-on lube oil filter adaptor assembly with a temperature-sensitive thermatic oil control valve is available on Series 60, 11.1L low compression (15:1) industrial…
The oil filter adaptor is located on the right side of the engine and is attached to the oil cooler. The 1991 and later…
Two full-flow type lubricating oil filters are used on current Series 60 engines. The oil filters are mounted in a downward position. The filters are…
Certain pleasure craft marine engines use a single, high capacity, remote-mounted lubricating oil filter. When installed, adaptor plates drilled and tapped for hose connections are…