The following troubleshooting chart resolves erratic performance and no codes displayed. For troubleshooting procedures, refer to the appropriate engine service manual. Cannot get full power.…

The following procedures will diagnose engine cranks but will not start. Check Engine Light Perform the following steps to check the CEL: 1. Turn ignition…

SAE faults and flashcodes withdescriptions, sortedby SID, are listed in Table 5-3.

SAE faults and flashcodes with descriptions,sorted by PID, are listed in Table 5-2.

To read codes, use the diagnostic data reader or depress and hold the diagnostic request switch with the ignition ON, engine at idle or not…

The Electronic Foot Pedal Assembly (EFPA) contains the Throttle Position Sensor (TPS) that converts the hand throttle and/or foot pedal input from the operator into…

An Ambient ATS Kit (P/N: 23524171) is available through the Canton Parts Distribution Center. The Kit contains all the necessary hardware to install an Ambient…

The Ambient ATS is a thermistor type sensor with a variable resistance that produces an analog signal between 0 and 5 V, representing the temperature…

The open collector input is defined as a single wire input that alternates between a high voltage of at least 4 V DC and a…

The magnetic pickup requirements are listed in Table 3-13. Magnetic pickup size is determined by installation requirements. Both circuits 556 and 557 must be used.…