Detroit Diesel Troubleshooting Diagrams

Archive for the ‘Fuel Temperature Sensor’ tag

Series 60 Fuel Temperature Sensor

without comments

The Series 60 diesel engine Fuel Temperature Sensor (FTS) is installed into the secondary fuel filter.The FTS sends an electrical signal to the ECM indicating fuel inlet temperature. The ECM uses this information to calculate fuel consumption.

Series 60 Fuel Temperature Sensor Series 60 Fuel Temperature Sensor

 

Written by sam

September 28th, 2011 at 5:04 am

Posted in Fuel System

Tagged with

Fuel Temperature Sensor Series 60G Engine

without comments

On DDEC III/IV engines there is an Air Temperature Sensor (ATS) mounted to the bottom of the inlet elbow. The ATS sends an electrical signal to the ECM indicating the inlet manifold temperature of the air entering the engine. The ECM uses this information to adjust gas flow, control air fuel ratio and in some cases fan control. The ATS provides necessary input to vary hot idle speed and injection timing resulting in improved cold starts and reduced white smoke.

The Series 60 natural gas engine air temperature sensor (ATS) is installed into the air inlet tube. The ATS sends an electrical signal to the ECM indicating air inlet temperature. The ECM uses this information to adjust gas flow and control air fuel ratio. ‪

Fuel Temperature Sensor Series 60G Engine Fuel Temperature Sensor Series 60G Engine

1. Fuel Temperature Sensor ‪ 5. Air Inlet Elbow ‪
2. PSV ‪ 6. Low Pressure Regulator ‪
3. Fuel Mixer ‪ 7. Air Temperature Sensor ‪
4. Throttle ‪ 8. Fuel Pressure Sensor ‪
9. Fuel Inlet Tee-Fitting ‪

Written by sam

September 28th, 2011 at 4:35 am

Posted in Fuel System

Tagged with

You might also likeclose