Drain system as follows:
- Remove the fuel feed line from the fuel filter module.
- Install J-48710 fuel pressure test kit onto the fuel feed line at the module.
- Do NOT remove the return line from the module.
- Use regulator and adjust the system pressure to 50 psi.
- After one to two minutes the system should be drained of fuel.
- Remove test equipment.
Related Posts
-
DD15 Water-in-Fuel SensorThe Water-in-Fuel Sensor determines the electrical resistance between the two sensor electrodes (2). If the water level increases in the…
DD15 Fuel Rail Pressure SensorThe fuel rail pressure sensor uses a sensor element and a hybrid element. As pressure increases the sensor membrane will…
DD15 Fuel Filter LifeThe fuel system consists of three main filters. The prefilter has the task of filtering material down to 100 micron.…
-
