From the oil inlet in the center housing, the oil flows through the drilled oil passages in the housing to the shaft bearings, thrust ring, thrust bearing, and backplate or thrust plate.
| 1. Compressor Wheel |
6. Shaft |
| 2. Thrust Bearing |
7. Turbine Wheel |
| 3. Backplate |
8. Shaft Bearings |
| 4. Oil Inlet |
9. Oil Outlet |
| 5. Center Housing |
Related Posts
Series 60 Turbocharger Oil Lines Oil for lubricating the turbocharger is supplied under pressure through an external oil line extending from the oil filter adaptor…
-
Series 60 Defective TurbochargerTo determine if a defective turbocharger is causing excessive oil consumption, perform the following: 1. Remove the turbocharger drain…
Series 60 TMF Turbocharger The TMF turbocharger is used on 1990 and later 12.7 liter displacement engines, except heat exchanger-cooled pleasure craft marine engines.
Series 60 External Oil LeaksTo determine if oil leaks are causing excessive oil consumption, perform the following: 1. Start and run the engine to…
