Detroit Diesel Troubleshooting Diagrams

Series 40E Valve Cover Intake Manifold

without comments

Use the following procedure to remove the valve cover/intake manifold. ‪

  1. Disconnect the main wiring harness connector from the valve cover/intake manifold.
  2. Remove 13 valve cover/intake manifold capscrews.
  3. Lift the valve cover/intake manifold; bend back the tabs located in the wiring channel harness.
  4. Disconnect the six fuel injector solenoids from the wiring harness by spreading the tabs and pushing down. Or, release the retaining tabs of the wiring harness connector and push the connector body toward the inside of the valve cover/intake manifold. Remove the valve cover/intake manifold, leaving the wiring harness connected to the fuel injectors.

valve cover Series 40E Valve Cover Intake Manifold

5.       Remove valve cover/intake manifold and gasket from cylinder head. See Figure 31073 and see Figure 31074 .

valve cover removal 1024x597 Series 40E Valve Cover Intake Manifold

None found.

Written by sam

November 28th, 2015 at 10:35 pm

Posted in Engine

Leave a Reply

You might also likeclose